Choose Favorites List

#12 x 2-1/2" Zinc Plated Phillips Flat Head Sheet Metal Screw

KL Jack Quality Vendor
Item #: 12D250TXFZ
$12.45 /Box
Only $0.12 Each
Package Size: 100

Quantity Discount

Buy10+ Buy25+ Buy50+ Buy100+
$11.49 $10.7240 $9.9580 $9.0005

Total Price: $12.45

Sheet Metal Screws, also referred to as Self-Tapping Screws, are a hardened screw with a fully threaded shank, sharp spaced threads and a sharp pointed (gimlet) tip that allows them to cut into thin gage metal, wood, plastics, fiberglass and other suitable materials.

Sheet metal screws can pierce, thread into and fasten many softer materials without pre-drilling, but for use in materials such as sheet metal and hard woods a correctly sized pilot hole should be pre-drilled before these screws can be used successfully. When used in thin gage metals with a pre-drilled pilot hole a self-tapping screw is capable of cutting it’s own threads into the hole for securely fastening two metal items together, fastening wood to metal or metal to another suitable substrate material.

Our zinc plated steel Sheet Metal Screws feature a sharp Type A or AB style point with a more closely spaced thread form that allows their use over a wide range of materials and material thicknesses. They are available in head styles such as Hex, Pan, Truss, Countersunk Flat or Oval Heads. They feature a clear zinc chromate plating to provide protection against normal atmospheric corrosion, but they will rust when exposed to the elements, moisture or chemicals.

Flat Head Sheet Metal Screws feature an 82° Countersink style flat head that will fit flush with the surface when fully installed. The length of a Flat Head sheet metal screw is measured overall from the top edge of the screw head. A rule of thumb for determining correct pilot hole size for a screw is to drill a hole in the size range of it’s minor diameters, (see Tech Specs below). We have included a suggested Pilot Hole size for metal in our Technical Specifications section on this page. When necessary, a test installation may be required to confirm the correct pilot hole size for fastening into different thicknesses and types of materials. Flat Head Sheet Metal Screws are also available in both 18-8 and 316 Stainless Steel.

Manufacturer KL Jack Quality Vendor
Item Type Flat Head Sheet Metal Screw
System of Measurement Inch
Drive Type Phillips
Diameter #12
Diameter (Decimal) 0.2160"
Length (inches) 2-1/2"
Countersink Angle 82°
Major Diameter 0.215" max / 0.208" min
Minor Diameter 0.164" max / 0.157" min
Drive Size #3
Finish Zinc Plated
Grade Case Hardened
Head Diameter 0.412" max / 0.380" min
Head Height 0.132" max / 0.112" min
Head Style Flat
Material Steel
Pilot Hole Size 3/16" (In 1/8" steel)
Point Type A/AB
Dimensional Specification ASME B18.6.3
Threads Per Inch 14
Thread Style Full